|
Eliminators & Louvers |
|
PVC Mist Eliminators / Louvers for Humidification
and Ventilation systems |
|
A wide
range of PVC Eliminators and Louvers for use in Air
washers, Humidification plants, Ventilation systems,
Air handling units, Cooling towers, Cooling coils and
such diverse applications to serve Textile, Cement,
Power, Coal and many other industries.
|
 |
 |
|
Eliminator C - 23 - Profile width 170 mm
For use at a pitch of 25 mm |
Eliminator W - 34 - Profile width 170 mm
For use at a pitch of 29.5 mm |
 |
 |
|
Eliminator S - 45 - Profile width 150 mm
For use at a pitch of 30 mm |
Eliminator V - 36 - Profile width 255 mm
For use at a pitch of 30 mm |
 |
 |
|
Eliminator M - 56 - Profile width 250 mm
For use at a pitch of 30.5 mm |
Eliminator N - 78 - Profile width 220 mm
For use at a pitch of 30 mm |
 |
 |
|
Eliminator L - 67 - Profile width 215 mm
For use at a pitch of 25 mm |
Eliminator SM - 16 - Profile width 280 mm
For use at a pitch of 25 mm |
 |
 |
|
Louver – Z type - Profile width 25 + 84 + 13 mm
For use at a pitch of 60 or 75 mm |
Louver – H-22 - Profile width 45 + 80 + 35 mm
For use at a pitch of 75 mm |
|
|
Mist
Eliminators are used in applications where the purpose
is to increase humidity in supply air, to reduce air
temperature, to remove dust from air supply or a mix
of two or more of these factors.
Extruded
from the best available PVC in India on twin screw
extruders of Kabra ExtrusionTechnik (Kolsite –
Battenfeld collaboration), our products are made to
give a trouble free service for years. The material is
recommended for a maximum continuous operating
temperature of 60o C due to inherent properties of the
material, Poly Vinyl Chloride. |
|
The eliminators are
available in tailor made lengths. The customer has a
choice of having the material packed in |
- Corrugated cartons covered with jute packing
which gives a low cost packing suitable for normal
handling in road transport but has a risk of
breakage of some pieces in transit and breakage free
transit cannot be guaranteed OR
- Wooden crates which offer good protection
against the rough and tumble of road transport, but
at a higher cost of packing and added cost of
transportation due to increased weight and volume of
packing.
|
|
Eliminators can be
installed by |
- fixing into spacer bars / notched plates / combs
which are fixed on PVC stiffeners / G.I. angles
supported on side walls
- fixing into boxes made of PVC stiffeners / G.I.
angles
- fixing into boxes made of G.I. / Aluminium
sheets
|
|
Louvers can
be installed by fixing them into special frames made
of PVC stiffeners / G.I. angles.
We have
developed fixing material in which all load bearing
M.S. material is completely encased by PVC, avoiding
costly hot dip galvanizing process. As the basic
design of existing system of fixing on M.S. angles is
maintained, there is no change in the manner in which
eliminators / louvers are being installed at present.
Corrosion which cannot be prevented even with costly
surface treatment processes, has a limited effect on
this type of fixing materials. Design has been
modified to discard bolting requirements wherever
possible. |
